![](/images/new-backgrounds/1120994/12099417x1.webp)
Step 7: Set IP Address with CLI or CLU
At this point, you are in the CLI. You can continue using the CLI to make network settings or you can switch to the CLU.
•CLI (below)
•CLU (page 10)
CLI
1.Type the following string to set the Management Port IP address and other settings, then press Enter.
administrator@cli> net
In the above example, the IP addresses and subnet mask are included as examples only. Your values will be different.
If you prefer to let your DHCP server assign the IP address, type the following string, then press Enter.
administrator@cli> net -a mod -t mgmt -s "dhcp=enable"
2.To verify the settings, type net and press Enter. administrator@cli> net
===========================================
CId Port Type IPMask Gateway Link
===========================================
1 1 Mgmt 192.168.10.87 255.255.255.0 192.168.10.3 Up
This completes the Management port setup. Go to “Step 8: VTrak Setup with Embedded WebPAM” on page 12.
To see the full set of CLI commands, at the admin@cli> prompt, type help and press Enter.
9