Printer Configuration
Note: After pressing the Enter Button to move from Emulation to WLAN Type, the printer will pause and display “Waiting for
WLAN Type
Possible Values: Infrastructure*,
WLAN Type Infrastructure
This feature specifies the type of wireless network the printer will be attached to. An Infrastructure network consists of nodes that connect to each other and/or a wired network through an Access Point. A
WLAN Channel
Possible Values: 1* … 14
WLAN Channel 1
Note that this feature is only available if the WLAN Type is set to
This feature sets the radio channel to be used when communicating in a
WLAN SSID | WLAN SSID |
| any |
Possible Values: any*,
Up to 16 characters of “0” through “9”, “A” through “Z”, “a” through “z”,
This feature specifies the “name” of the network the printer will connect to. This allows communications to be controlled, or routed to the appropriate nodes when multiple wireless networks are present. When set to “any”, the printer may connect to any available network(s).
To advance through the character positions, press the Advance Button. To change the character at the current position, press the Increment Button. The order of characters that may be selected is “0123456789 ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyz”.
WLAN WEP Bits
Possible Values: 0*, 64, 128
WLAN WEP Bits 0
This feature specifies the level of Wired Equivalent Security to use. If set to “0”, security is turned off. If set to a“64” or “128” bit encryption level, a WEP Key must be entered that matches the key on the other nodes on the network.
27