2.Rotate the VOL button to choose the desired item.
Remote control operation
Press button (29) to choose the desired item.
Display/Adjust Time
1. Displaying time:
Press DISP button (7) to show current information and time on the LCD, and it returns to original status after 5 seconds.
2. Adjusting time:
1). Press and hold DISP button (7) until the clock blinking.
2). Press or button to move to between hour area and minute area.
3). Rotate VOL button (6) or to adjust hour or minute.
LCD Display (8)
Exhibit current information and activated functions on the LCD display (8).
Remote Sensor
Point the remote control handset to the remote sensor IR (9). Press the function keys on the handset to control the system.
Flashing Led (10)
The led display will flash if the front cover is not inserted into the main unit.
ESP function
If the unit has the electronic shockproof function, it can be shockproof about several seconds:
CD, VCD: 18 seconds.
MP3: 160 seconds.
DVD: 6 seconds.
MPEG4: 20 seconds. Loudness on/off
Loudness introduces a special low- and
Equalization
Press EQ button (12) to turn on
equalization function and to select desired audio mode. There are four kinds of mode as below:
EQ FLAT EQ CLAS
EQ ROCK EQ POP
Mute Function
Press MUTE button (2) to silence the sound instantly, press it again to resume previous volume level.
Mode Function
Press MODE button (13) to switch to the desired mode.
The mode will change every time the button is pressed.
DISC/USB/SD TV AV IN TUNER
Last Position Memory
-During disc playback, if you press button (2) to turn off the unit and then press the button again to turn on the unit, the DVD unit will resume playing from the point that it was interrupted.
-During disc playback, if you press MODE button (13) to switch to other mode, and then return to DVD/VCD mode again, the unit will resume playing from the point that it was interrupted.
This unit is equipped with a
(6)repeatedly to select SUBW and then rotate VOL button to turn
Reset Function
RESET button on the housing must be activated with either a ballpoint pen or thin metal object. The RESET button (1) is to be activated for the following reasons:
-Initial installation of the unit when all wiring is completed.
-All the function buttons do not operate.
8