Using the Mixer Controls
Turning on the Mixer
1.Turn on the output amplifier and temporarily set its volume to the minimum setting.
2.On the mixer, turn ON the power switch. The adjacent power LED will illuminate.
3.Turn on the audio input sources you wish to mix, and set them to play (or talk continuously into the microphone).
4.To monitor the audio input sources so that you can decide when to mix in each input, see “Monitoring ‘Cueing’ the Inputs.”
5.To mix the audio input sources so that you can play them through your amplifier system or record them on your tape deck, see “Mixing the Inputs.”
Monitoring (”Cueing”) the Inputs
Follow these steps to monitor the audio input sources.
1.Perform Steps 1 and 2 of “Turning on the Mixer” and put headphones on.
2.Set the CUE switch of the input source (CH1, CH2 or CH3) to the ON position.
CUE switch
3.Set the desired audio input source’s volume to its minimum setting, turn it on, and set it to play (or speak continuosly into the microphone).
4.Slowly turn the CUE LEVEL control clockwise until you hear the signal through the headphones at the desired volume level.
CUE Level
Control
5.Repeat Steps
6 – Pyle Pro Mixer Owner’s Manual
