Mixing the Inputs
Follow these steps to mix the audio input sources.
1.Perform Steps 1 and 2 of “Turning on the Mixer.”
2.Set the selected audio input source’s volume to its minimum setting, turn it on, and set it to play (or speak continuously into the microphone).
3.Set the following input source selectors as desired:
Input Source Selector Switches
| Mixer | Audio Input | |
| Channel | Source | |
|
|
|
|
1 | Turntable connected to PHONO1 | ||
High level output audio source connected to the LINE 1 jacks | |||
|
|
|
|
| 2 | Turntable connected to PHONO2 | |
High level output audio source connected to the LINE 2 jacks |
| ||
3 | High level output audio source connected to the LINE 3 jacks | ||
High level output audio source connected to the LINE 4 jacks | |||
4.Set the Channel 1, Channel 2 and Channel 3 volume control sliders to approximately
5.Rotate the Master Volume Control clockwise until you observe an average reading of “0” (zero) on both Output Level LED meters, and leave it at that setting. (Please note that the Output Level LED meter indicates the total output signal being mixed from all sources for each of the Left and Right channels.)
6.When adding an audio input source to the mix, adjust the corresponding Channel 1, 2 and 3 volume control sliders so you maintain the average reading of “0” on both Output Level LED meters.
7.Adjust the receiver/amplifier volume control to the desired volume.
8.To turn off the mixer, push the Power switch to the OFF position; the Power LED will be extinguished.
Input Source
Volume Control Sliders
Pyle Pro Mixer Owner’s Manual – 7
