Section 2: Installation- Connections
CONNECTING AUDIO INPUTS
The audio inputs are located on the rear panel. The CM16a uses
the audio inputs. These connectors allow the installer to
rack. It also allows for
locations without the need for any tools. See Appendix for connector manufacturer’s
part number reference. | BALANCED INPUT CONNECTION | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Balanced connection is recommended for all inputs. If unbalanced audio sources are used, it is preferable to use an appropriate audio transformer (or other unbalanced-
UNBALANCED INPUT CONNECTION
The recommended stripping length for the wires is approximately 6 to 8 mm ( 1/4 to 5/16 inch). When stripping the audio cable, be careful not to nick or cut the conductor strands. After each conductor has been stripped and dressed, insert it fully into the connector and tighten the retaining screw. When stranded wire is used, carefully twist the conductor strands together so that when they are inserted into the connector assembly, no loose strands short adjacent terminals.
STRAIN RELIEF
For
19