Section 1: Introduction- List of Functions & Features
FUNCTIONAL LISTING, BLOCK DIAGRAM & DETAILED DESCRIPTIONS
The CM16a performs control and monitoring of amplifiers remotely. Below is a listing of the functions that are available for the supported QSC amplifiers. The following two pages (Block Diagram part 1 & 2) graphically illustrate the main functions of the CM16a. Following the diagram is a section giving detailed explanations on each functional block that will aid in the use of the CM16a. Note that not all features may be supported by the current revision level of software (consult software documentation for supported feature set). Where applicable, functions are available on each individual channel.
CONTROL FUNCTIONS
Amplifier: | Power (Standby/Operate Control) |
|
CM16a: | Input Sensitivity Select | Input Source Select (Normal/Page) |
| Signal Level Control | Signal Mute |
| Signal Polarity Select | Paging Control (with customizable routing) |
| Contact Closure Output (switching of internal relay for control of external device) | |
| Paralleling within DataPort Pair |
|
MONITOR FUNCTIONS
Amplifier: | Power Status | Amplifier Gain |
| Amplifier Model | Bridge Mode |
| Load Monitor (impedance) | Protection Status |
| Output Voltage | Output Current |
| Output Power (real) | Heat Sink Temperature (with |
| Headroom | Clipping Detect |
| Output Short | Output Open |
| Output Level Meter |
|
CM16a | Input Level Meter | Output Level Meter |
Audio Monitor Module (4 channel mono. mixer)
External Event Sensing (a
SPECIAL FEATURES
DAC
TFTP upgradeable firmware
8