Section 1: Introduction- Quick Start
This quick start section is for those users who want to get up and running with the
This is the same material covered in the Signal Manager software help file, only presented on paper so that you may “get right to it”.
1 | TURN THE EQUIPMENT OFF & INSTALL THE HARDWARE | |
| If you are using the | Then you need to |
QSC Powerlight2, CX, DCA
QSC
QSC Powerlight 6.0 or Powerlight 9.0
Mount the
Mount the
Mount the
QSC Powerlight, all except 6.0 & 9.0
a
Mount the
Mount the
2 | CONNECT THE COMPUTER TO THE |
Use a
connector on the back of the PC). COM1 through COM4 are usable with the Signal Manager software. COM1 is the default port in Signal
Manager; use COM1 for your connection if it is available. If not, you will need to select the appropriate COM port in the Signal Manager
program after you install it in step 5.
7