Section 1: Introduction- Quick Start
5 | INSTALL THE SOFTWARE |
1.Place the QSC Signal Manager CD in your computer’s CD drive (typically the D:\ drive). The installation program should run automatically after several seconds; if it does not, then proceed with step 2:
2.Run D:\Setup.exe (replace D: with the drive letter designator appropriate for your system) and follow the instructions displayed.
3.When the installation is complete, you will be presented with a screen that prompts you to view the “Readme” file. Please take time to read this- it contains important
4.After installation, you will have an icon on your computer’s “desk top” labeled Signal Manager. Use this icon to start the application
5.Using the Menu Bar (see below) at the top of the window, choose the “Help” item and read the software help section. The help system includes the contents of this hardware manual for “paperless” reference.
6.IMPORTANT! The
THIS MAY NOT BE APPROPRIATE FOR YOUR SETUP! Be sure to configure any necessary crossovers , filters, etc. prior to applying audio signals to the inputs. Damage to equipment may result if these recommendations are not followed.
WHAT THE SIGNAL MANAGER APPLICATION LOOKS LIKE
This
TITLE BAR | DRAWING TOOLS PALETTE | INPUTS AND OUTPUTS PALETTE | |
MAIN PALETTE |
| FILTERS PALETTE | MISC PROCESSORS PALETTE |
DSP TOOLS PALETTE | |||
MENU BAR |
|
|
|
FILE VIEW PANE
WORKSPACE PANE
CURSOR POSITION PANE
STATUS BAR | SPLITTER BAR | RESOURCE METER PANES |
|
|
| CONFIGURATION STATUS PANE | CAPS LOCK INDICTAOR |
|
| COMMUNICATION STATUS PANE | NUM LOCK INDICATOR |
|
|
|
9