Installing the Software
4.3.1Installing the Target Linux Software
This section explains how to install Linux for use on the target board. This is a demonstration version of MontaVista Linux Pro v5.0.
Note that separate versions of Linux are used by the target and your host Linux workstation. The following Linux host operating system is tested with the DVEVM: Red Hat Enterprise Linux v4 (Server Edition).
To install the Linux software, follow these steps:
1)Log in as root on your host Linux workstation. This will allow you to successfully run the graphical installer to install MontaVista Linux.
2)Execute each of the following bin files (where #_#_#_# is the current version number) from the temporary location that they were copied in order to extract the installers for the Linux tools, Linux kernel, and the file system. If a bin file does not run, make sure these files are executable (use chmod +x *.bin).
Instead of the default installation directory, we suggest that you change the installation directory to /opt/mv_pro_5.0.
host $ ./mvl_5_0_demo_sys_setuplinux.bin
host $ ./mvl_5_0_0_demo_lsp_setuplinux_#_#_#_#.bin
3)After you execute these .bin files, make sure the following files are located in /opt/mv_pro_5.0 (or in the /mv_pro_5.0 subdirectory of the directory you chose in place of the default):
■mvltools5_0_#######.tar.gz
■DaVinciLSP_#_#_#_#.tar.gz
4)Go to the location where you will unpack the tar files. For example:
host $ cd /opt/mv_pro_5.0
5) Unpack the tar files (as root) by using the following commands:
host $ tar zxf mvltools5_0_#######.tar.gz
host $ tar zxf DaVinciLSP_#_#_#_#.tar.gz
This creates the MontaVista directory structure under the /opt/mv_pro_5.0/montavista/ directory.
Note that unpacking these tar files will overwrite any existing files that were previously installed.
Note: The LSP shipped with the DVSDK is a
