Texas Instruments TMS320DM6446 DVEVM v2.0 manual Setting Up the Hardware

Setting Up the Hardware

2.1Setting Up the Hardware

To set up the hardware provided with the EVM, use the steps in the sections that follow. You may skip sections if you do not need to access a particular peripheral. For example, if you do not need to use the serial cable, skip that section.

1)The EVM is sensitive to static discharges. Use a grounding strap or other device to prevent damaging the board.

Be sure to connect communication cables before applying power to any equipment.

2)If you use PAL video, set switch 10 on the S3 (USER) bank of switches to On. If you use NTSC video, set this switch to Off. See Figure 1–1 for S3 switch bank location.

3)Connect the yellow video cable to the upper-right Video Out jack on the EVM and the LCD display Video Input as shown below.

See Section A.1, Changing the Video Input/Output Methods for

information about using S-Video or Component video.

2-2