Connections
AC Power Cord
Insert the molded receptacle of the AC power cord into the AC power inlet on the back of the DSP 322ua. Plug the AC line connec- tor into the AC outlet. The power supply will accept from 100 to 240 Volts AC, 47 to 440 Hertz, without any changes. If a different type of IEC power cord is required than the one supplied with your 522aa, contact QSC’s Technical Services Department.
QSControl
Connect one end of a
QSControl connection: accepts ruggedized or normal
Analog Universal Audio Inputs
Eight balanced audio inputs are provided, CH 1 INPUT - CH 8 INPUT. They accept everything from mic level to line level signals and are equipped with
Each input has
Analog Audio Outputs
Eight balanced audio inputs are provided, CH 1 OUTPUT - CH 8 OUTPUT. Plug the output signal terminal block connectors into the output receptacles. Connection
Omni In
The six Omni In connectors are
Analog audio input and out- put- balanced connection.
Analog audio input and output- unbalanced con- nection. Note jumper wire between - and ground.
Omni In connections. Vari- able input must be 10k ohm variable resistor. Contact closure input can be a switch or relay contacts. These inputs can operate software “devices”. Nega- tive
Logic Out
The four Logic Out connectors are
Logic Out connections. Negative
(+)terminal logic level is switched using software.
10