SYSTEM HOOKUP EXAMPLES
SUBWOOFER AND TOP BOX
Move the CROSSOVER switch to | INPUT |
the CROSSOVER position. |
|
Connect a single source, into the |
|
Ch 1 input. |
|
Connect a subwoofer to the |
|
Ch 1 output and connect a |
|
|
SET TO CROSSOVER
8 OR 4 OHM
TOP
8 OR 4 OHM
SUB
POWERING HOUSE AND MONITOR SPEAKERS
8 OHM | 8 OHM |
MAIN | MAIN EN |
Set the CROSSOVER switch to the FULL RANGE position. Use a mixer with Main and Monitor outputs. Connect cables into Ch 1 and 2 respectively. Connect Ch 1 output to
two large speakers. Connect Ch 2 output to two floor wedges.
SET TO FULL RANGE |
STEREO PLAYBACK
Set the CROSSOVER switch in the FULL RANGE position. Connect a Left / Right signal source to channel 1 and channel 2 respectively using XLR, TRS or PHONO connectors. Connect a speaker to each channel using SPEAKON, ¼’ PHONE, BANANA JACKS or WIRE.
| 4 OR | 4 OR |
OR | 8 OHM | |
| 8 OHM | |
| L | R |
SET TO FULL RANGE |
|
|
USING BOTH CHANNELS FOR THE SAME
Move the CROSSOVER switch to the
FULL RANGE position. Hook up a single source using Ch 1 XLR input. Install a RTS jumper going between Ch1 and Ch2.
Connect a speaker to each channel. Each speaker ahs its own gain adjustment on the front panel.
DO NOT connect both channels Into the same speaker.
FULL RANGE
SET TO FULL RANGE |
L1 | L2 | ||
4 OR | |||
8 OHM | 4 OR | ||
|
| 8 OHM | |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DO NOT connect both
Channels to the same speaker.
RTS jumper between CH1 and CH2
