QSC Audio AF2102-LA Front Articulated Joint Knuckle Hardware, Rear Link Angle Adjust Hardware

Rigging

WideLine-10 enclosures use a three-point suspension system. The system consists of front, left/right, captive articulated joints and a single rear link bar. Articulation is in 2° increments using the first location on the link bar. With the use of the second location, 1° degree increments can be obtained starting at 3°. The total available angular increments are: 0, 2, 3, 4, 5, 6, 7, 8, 9, and 10°. All pieces and locking pins remain with the enclosures. No ancillary items are needed to suspend the enclosures from the WideLine-10 array frame. All ball-lock pins are equipped with a lanyard to help prevent loss.

Front Articulated Joint (Knuckle) Hardware

Expose the end of the articulated joint by locating the joint’s retaining screw protruding from the front of the receiver tube and sliding it upward. The front captive joint will slide upward from the enclosure’s receiver tube.

The exposed end of the articulated joint can now be inserted into the adjacent enclosure’s receiver tube and locked into position by a locking pin. This is repeated for each side of the enclosure. Then the rear link bar can be rotated into position and pinned at the chosen increment.

1

2

1. Front Articulated Joint—Slide the joint out of the receiver tube by sliding the retaining screw upward.

2. Then lock in place using the ball-lock pin.

Rear Link (Angle Adjust) Hardware

The rear link is stored with the link folded between the sides of the block. To expose the link, remove the ball-lock pin and rotate the link into the desired position. Once positioned, the link is secured using the ball-lock pin of the adjacent enclosure.

The rear link is marked with a thin, white line at the “normal” (0°) position and with a “+3” at the +3° position.

The additional ball-lock pin hole (located approximately midway on the link) is used for storing the link when folded into the enclosure’s block for storage. The link may be pinned in place at the 0° or 8° location on the block when rotated into the storage position.

1.Rear Link—Remove the ball-lock pin from the storage position, then rotate the link down- ward to the adjacent enclosure.

2.Lock in place using the ball-lock pin.

1

2

6