Adjusting the Angle Between Enclosures (Splay)
The illustration shows the rear pin block of two enclosures joined by the upper enclosure’s rear link arm.
Use the first pin location (closest to the end) on the link arm for setting in normalized 2° increments. The
When the “+3“ location is used, an additional 3° are added to the “normalized” location. The right side example shows two enclosures linked for 9° of splay. The
Rear link attached to achieve an 8° splay between enclosures.
Rear link attached to achieve a 9° splay between enclosures.
AF2102-LA and WL Small Grid
There are two array frames available for the
The
The WL Small Grid is a compact and easier to handle frame for use as a small array or stacking frame. This frame will easily sit on ground stacked bass enclosures or it can be used to suspend smaller arrays from the stage trusses.
AF2102-LA
Use only the QSC supplied 5/16" diameter x 1.25" long
The three pick up rails allow for any number of rigging solutions to fit the most demanding venues. The rails are drilled for industry standard 5/8" shackles.
Do not stack more than eight (8) enclosures on the
Left pickup rail | Center pickup rail | Right pickup rail |
Front
31.6"
(803 mm)
14.8"
(376 mm)
Bolt on receiver tube and 5/16" diameter, 1.25" long
37.0"
(940 mm)
7
