Quadra-Fire CASTILE-GAS-CSB, 7023-111E Appliance Setup, Remove Shipping Materials, Accessories

8Appliance Setup

A. Remove Shipping Materials

Remove shipping materials from inside or underneath the

firebox.

B.Accessories

Install approved accessories per instructions included with accessories. Refer to Section 12 for appropriate accesso- ries.

CAUTION

Sharp Edges

•Wear protective gloves and safety glasses during installation.

WARNING

Shock or fi re risk.

Use ONLY optional accessories approved for this appliance.

•Using non-listed accessories voids warranty.

•Using non-listed accessories may result in a safety hazard.

•Only Hearth & Home Technologies approved accessories may be used safely.

Figure 8.2 Remove the inner collar adapter.

C. Top to Rear Vent Conversion

KIT CONTENTS: Rear vent grill.

TOOLS REQUIRED: Power drill; #2 Phillips bit; high-temp silicone sealant (optional.)

Figure 8.1 Remove top trivet, if installed. Remove vent pipe adapter and gasket by removing 4 screws as indicated. (If gasket breaks, apply high-temp silicone to bottom of adapter before installing (shown in Figure 8.4).

Figure 8.3 Remove the rear valve cover shield. Remove the rear access plate and gasket by removing four screws. Save the screws. Place the cover shield and gasket over the top vent and attach with the four screws previously removed.

	Figure 8.4 Insert the inner collar adapter to the rear vent
	fl ue.
July 29, 2008	Quadra-Fire · Castile Gas Stove · 7023-111E	Page 29