6Gas Information
A. Fuel Conversions
Before making gas connections ensure that the appliance being installed is compatible with the available gas type.
Any natural or propane gas conversions necessary to meet the appliance and locality needs must be made by a quali-
fied technician using Hearth & Home Technologies specifi ed and approved parts.
NOTE: Do not remove the retaining clip from the hood.
5/32 in. (4mm)
Allen wrench
1. Converting to LP Gas
NOTE: Gas conversions should only be performed by a qualified service person, and/or where required by state and local codes, licensed installer/service technician. In the Commonwealth of Massachusetts, installation must be performed by a licensed plumber or gas fitter.
KIT CONTENTS: Replacement ori ce; replacement pilot injector; valve regulator; conversion label.
TOOLS REQUIRED: #2 phillips screwdriver, slotted screw- driver or Torx TH20, 5/32 in. Allen wrench, 3/32 in. Allen wrench, 5/8 in. open end wrench, 7/16 in. socket, socket wrench, and extension.
Figure 6.3 Use a 5/32 in. Allen wrench to remove the pilot injector. Replace pilot injector with the one supplied with the appliance (#35 for Propane, #62 for Natural Gas). Replace the pilot hood, snapping into position.
Figure 6.4 Remove the main burner orifi ce using a 5/8 in, wrench. Replace orifi ce with the proper size as indicated for your gas type and venting.
Figure 6.1 Remove front, glass, and logs (if installed). Remove the optional brick set, if installed. Remove the two screws, one on each side of burner. Retain fasteners for rein- stallation. Lift burner up and out of the fi rebox.
Pilot Hood
Millivolt Generator
Thermocouple
PROPANE | NATURAL GAS |
.063 | .106 |
Reinstall burner by placing it into the fi rebox.
Installation is the reverse of the removal. Tighten thumb- screws only fi nger tight. DO NOT OVERTIGHTEN. Reinstall the optional brick set, if applicable.
Reinstall logs, glass and front.
Figure 6.2 Pull off the pilot hood and set it aside.
July 29, 2008 |
| Page 23 |
