Quadra-Fire CB1200-B F. Optional Log Set Placement Instructions, H. Installing Logo Nickel Only

Models: CB1200-B

1 48
Download 48 pages 55.05 Kb
Page 20
Image 20
F. Optional Log Set Placement Instructions

CB 1200 Pellet Stove

R

F. Optional Log Set Placement Instructions

G. Optional Gold or Nickel Grille Assembly

CAUTION

Logs are FRAGILE. Use extreme care when handling or cleaning logs.

1.Place the front log in first as shown in Figure 20.1. Place log between firepot and face of appliance with charred area surrounding firepot.

2.Set the left and right logs onto the front log, placing the holes in the base of the left and right logs over the locating pins in front log. See Figure 20.2. Ensure that the charred ends are facing the firepot.

LOCATING PINS

Figure 20.1

CAUTION

Do not open top all the way back so the weight of the top is supported by the hinges. It will damage the hinges. It will be necessary to prop the top up with a supporting brace. You can use the shipping box as shown in Figure 1.

1.Remove grille from packaging.

2.Lift top up and place shipping box in vertically.

3.Place 1 flap of the box lid into opening for stability.

4.Align the 3 holes in the stove with the holes in the grille.

5.Use a Phillips screwdriver to secure in place.

6.Remove shipping box and lower top.

Align the 3 hoes in the stove with the holes in the grille and secure in place.

Place 1 flap of box lid into opening for stability

CAUTION: Do not open top all the way back so the weight is supported by the hinges. It will damage the hinges. Prop the top up with supporting brace or use shipping box as shown.

Figure 20.3

Charred Areas in the Back

H. Installing Logo (Nickel Only)

 

 

 

 

1.

Remove logo from packaging.

 

 

2.

The logo has 2 studs on the back.

Top Log, Left

Top Log

3.

Install the logo on the lower left side of the center

 

Right

 

panel by pressing the 2 studs into the pre-drilled

 

Front Log

 

holes. See Figure 20.4.

 

 

 

Figure 20.2

 

 

NOTE:

 

 

Due to the abrasive nature of a pellet appliance fire, the

 

logs are not covered under warranty. Any placement varia-

Install Logo

tion other than shown here can cause excessive heat and

shall void the appliance warranty.

 

Figure 20.4

 

 

Page 20

7014-082D

September 1, 2008

Page 20
Image 20
Quadra-Fire CB1200-B F. Optional Log Set Placement Instructions, G. Optional Gold or Nickel Grille Assembly, Locating Pins