Log Assembly LOGS-QVI30FB, Log Placement | Quadra-Fire QVI-30FB-S

2020-144E 10/07

E. Positioning the Logs

Log Assembly: LOGS-QVI30FB

LOG PLACEMENT INSTRUCTIONS

Log Placement

CAUTION: Logs are fragile! Carefully remove the logs from the packaging.

	1
2		3
4	6	7
4	5	7

1

1

LOG #1 (SRV2020-140):Place log #1 by locating the legs of log over the air deﬂector. The notch or the back side of the log should center and sit against air deﬂector.

22	Quadra-Fire • QVI-30FB-S • 2020-910 Rev. H • 6/09

Image 22

Quadra-Fire QVI-30FB-S owner manual Log Assembly LOGS-QVI30FB, Positioning the Logs, Log Placement

Contents

Models Commonwealth of Massachusetts Homeowner Reference Information Model Number Serial Number Table of Contents Listing and Code Approvals Inspect Appliance and Components Design and Installation ConsiderationsGetting Started Tools and Supplies Needed Inspect Firebox Minimum ﬁreplace opening requirements are shown in Figure Fireplace Size RequirementsMinimum Fireplace Opening Location Clearances Clearances to Mantels or other Combustibles above Appliance Fire Risk Asphyxiation Risk Termination LocationsVent Termination Minimum Clearances Foot minimum in snow regions Horizontal Venting Vent Information and DiagramsVent Table Key Measuring Standards Installation Preparation Venting Components Installing Vent Pipe and ApplianceConnecting Vent Pipe Reference instructions in the termination kit Placing, Securing and Leveling the Appliance Factory Built Wood Burning Installing Adaptor and Termination CapMasonry Damper Flashing Kit Optional Fuel Conversions Gas Connection Refer to for location of gas line access in ap- plianceGas Information Gas Pressures High Altitude Installations Electrical Information Wiring the ApplianceON/OFF Switch Appliance Requirements Optional Accessories Junction Box InstallationInstallation for Fan Optional Shock hazard FAN Junction BOX Finishing Installing Trim SurroundsMantel Projections Accessories Appliance SetupClean the Appliance Ember Placement Log Placement Log Assembly LOGS-QVI30FBPositioning the Logs Quadra-Fire QVI-30FB-S 2020-910 Rev. H 6/09 Quadra-Fire QVI-30FB-S 2020-910 Rev. H 6/09 Removing Glass Assembly Glass AssemblyAir Shutter Setting Replacing Glass Assembly This appliance has a Standing Pilot Ignition Operating InstructionsBefore Lighting Appliance Before operating this appliance have a qualified technician Lighting Appliance Standing Pilot Ignition After Appliance is Lit Initial Break-in ProcedureCheck Pilot Flame Appearance Do not operate appliance with glass door removed Frequently Asked Questions Symptom Possible Causes Corrective Action TroubleshootingStanding Pilot Ignition System Symptom Possible Cause Corrective Action TroubleshootingMaximum ﬂame impingement. Follow lighting instruc Maintaining and Servicing Appliance Maintenance TasksRisk of injury or property damage Inspect Maintenance Tasks Appliance Dimension Diagram Reference Materials Vent Kits Components Direct Vent Flex Liner Kits Beginning Manufacturing Date Oct Log Set AssemblyService Parts Ending Manufacturing Date Stocked Service Parts ListAt Depot Valve Assembly Be ordered from an authorized dealer Limited Lifetime Warranty Limited Lifetime Warranty Contact Information Important operating