Quadra-Fire QVI-35FB-S Appliance Setup, A. Remove Glass Assembly, C. Clean the Appliance

12 Appliance Setup

A. Remove Glass Assembly

See Section 12.G.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the firebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included with accessories. Refer to Section 5.

WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional acces- sories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty.

E. Ember Placement

WARNING! Risk of Explosion! Follow ember placement instructions in manual. DO NOT place embers directly over burner ports. Replace ember material annually. Improperly placed embers interfere with proper burner operation.

Ember material is shipped with this gas appliance. To place the ember material:

•Embers CANNOT be placed directly over ports. Care should be taken not to cover the lighting trail of ports (from back to front).

•Place dime-size pieces of Glowing Embers® just in front of the port trail, but not on or in between the ports (see Figure 12.1). Care should be taken so that the ports are not covered.Failure to follow this procedure will likely cause lighting and sooting problems.

•Place Mystic Embers on areas of base refractory away from port holes. Use this material to give the appliance a realistic ash bed.

•Save the remaining ember materials for use during appliance servicing. The embers provided should be enough for 3 to 5 applications.

BURNER PAN

AIR

SHUTTER

EMBER MATERIAL

(TOP SURFACE,

AND FRONT)

Figure 12.1 Placement of Embers

Quadra-Fire • QVI-35FB-S • 2178-900 Rev. B • 12/08 29