V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosen the setscrew on the controller bracket. See figure 19.
3.Slide the controller into or out of the armrest to the desired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Turn off the power to the controller.
2.Loosen the rear shroud fasteners and remove the rear shroud.
3.Unplug the controller connectors from the power module.
4.Cut the wire ties that attach the controller harness to the armrest.
5.Flip up the armrest so it is perpendicular to the floor.
6.Loosen the setscrew on the controller bracket. See figure 19.
7.Slide the controller out of the armrest.
8.Loosen the setscrew in the other armrest.
9.Place the controller in the other armrest.
10.Tighten the setscrew in each armrest.
11.Route the controller connector to the back of the power base and secure the controller harness to the armrest receiver with wire ties.
12.Plug the controller connectors into the power module. See figure 7.
13.Reinstall the rear shroud and tighten the fasteners.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat or
CONTROLLER BRACKET
SETSCREW
Figure 19. Underside of Armrest
Quantum 1103 Ultra | www.pridemobility.com | 27 |
