6 | Basic Operation Instructions | DX Scanner |
SELECT MODE
1.Press the On/Off Button on the DX compatible Master Remote used on your power chair. The Module Status LED on the Scanner will light up, indicating that it is in Standby Mode and ready for use.
2.Press the Select Switch once to activate the Scanner. All three Mode LEDs will light up.
3.After power up, the Scanner will begin running through the three modes— Drive, Seat, and Environmental. Each Mode LED will light up in sequence. To choose a mode, you must wait for its LED to light up, then press the Select Switch.
NOTE: The Scanner will run through each Mode LED five (5) times before returning to Standby Mode.
DRIVE MODE
1.Press the Select Switch when the Drive Mode LED is lit. Once selected, the Scanner will cycle through the available drive directions.
2.To move in any direction, wait
until the desired Directional LED is lit, then press and hold down the Select Switch to move your power chair in that direction. The Scanner will automatically return to the Forward Direction LED after any power chair movement. See figure 2.
Figure 2. Directional LEDs
NOTE: If the Select Switch is not pressed within three scanning cycles of the Drive Mode, the Scanner will exit that mode.
