8 | Basic Operation Instructions | DX Scanner |
ENVIRONMENTAL MODE
1.Press the Select Switch when the Environmental Mode LED is lit. Once selected, the Scanner will cycle clockwise from the top (forward) LED. See figure 2.
2.The first four LEDs are momentary selections, and the last four LEDs are latching selections. Momentary selections will allow the Scanner to continue its cycle immediately after the switch is released. Latching selections will not allow the Scanner to continue its cycle until the Select Switch has been pressed for a period of five seconds. The Scanner will remain in the selected mode until the Select Switch is pressed for a period of five seconds.
NOTE: If the Select Switch is not pressed within three scanning cycles of the Environmental Mode, the Scanner will exit that mode.
SCANNING SPEED ADJUSTMENT
The Scanning Speed is indicated by the amount of time any one LED is lit before the Scanner moves on to the next LED.
1.Press the Select Switch to power on the Scanner. Wait for the Mode LEDs to light up.
2.When all three LEDs are lit, press the Select Switch and hold it down. The Scanning Speed will reset itself to the amount of time you hold down the Select Switch.
NOTE: The Scanning Speed will need to be adjusted every time the Scanner is turned on. It cannot be permanently set.
