DX Scanner | Basic Operation Instructions | 7 |
SEAT MODE
1.Press the Select Switch when the Seat Mode LED is lit. Once selected, the Scanner will cycle clockwise around the seating commands (Directional LEDs).
2. There are four Seat Positioning Actuators represented by two each of the Directional LEDs.
For example, Actuator 1 is represented by the Forward and
the Forward Right Directional LEDs. See figure 3. To extend
Actuator 1, wait until the Forward LED is lit, then press
and hold down the Select Switch. To retract Actuator 1, wait until the Forward Right LED is lit, then press and hold down the Select Switch.
3.To operate a fifth actuator (if available), use the Environmental Mode LED (see figure 1). Wait until the Environmental Mode LED is lit, then press and hold down the Select Switch to extend the actuator. To retract the actuator, press and hold down the Select Switch again. If you have any questions regarding the use of the fifth actuator, please contact your authorized provider.
NOTE: If the Select Switch is not pressed within three scanning cycles of the Seat Mode, the Scanner will exit that mode.
