Quantum Quantum 1402 Seat Position, To change the seat position, To adjust the seatback angle

Models: Quantum 1402

1 47
Download 47 pages 53.36 Kb
Page 24
Image 24

V . C O M F O R T A D J U S T M E N T S

10.Move the seat towers up or down to the desired height.

11.Reinstall the ball detent pin into each seat tower.

12.Reinstall the shroud.

13.Reinstall the trapeze bars and secure with the quick- release pins.

14.Reinstall the seat.

WARNING! Make sure the seat latch safety is flipped down before using the power chair.

15. Plug the controller connector(s) into the electronics tray.

Seat Position

You can move the seat forward or rearward by changing the extrusion mounting position.

To change the seat position:

1.Turn off the power to the controller.

2.Unplug the controller connector(s) from the electronics tray.

3.Remove the seat from the power base.

4.Remove both extrusions from the bottom of the seat.

5.Reposition the extrusions on a different set of mounting holes. You must move both extrusions the same number of holes either forward or backwards. See figure 14.

6.Fasten the extrusions back onto the bottom of the seat.

7.Reinstall the seat.

8.Plug the controller connector(s) into the electronics tray.

Manual Recline Seatback Adjustment

If your power chair is equipped with a reclining seat, you can adjust the seatback angle with the seatback release le- ver. This lever is located on the right side of the seat base.

To adjust the seatback angle:

1.Pull up on the seatback release lever.

2.Lean forward or backwards to the desired position.

3.Release the lever.

Seatback Angle Adjustment

If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.

To adjust the seatback angle:

Figure 14. Seat Position Adjustment

JAM NUT

ARMRESTANGLE

ADJUSTING SCREW

ARMREST HEIGHT

ADJUSTING

SETSCREWS

SEATBACK ANGLE

ADJUSTING SCREW

ARMREST

ADJUSTMENT

KNOB

Figure 15. Seatback and Armrest Adjustments

1.Remove the seatback angle adjusting screws from both seat hinges. See figure 15.

2.Set the seatback at the desired angle.

3.Reinstall the screws on both seat hinges and retighten.

24

www.quantumrehab.com

Quantum 1402

Page 24
Image 24
Quantum Quantum 1402 manual Seat Position, To change the seat position, Manual Recline Seatback Adjustment