Quantum Quantum 1402 Power Elevating Seat Option, If your power chair is equipped with a power el

V . C O M F O R T A D J U S T M E N T S
Power Elevating Seat Option
If your power chair is equipped with a power el-	POWER ELEVATING
evating seat, you can change the seat height auto-
matically. The power elevating seat is operated	SEAT SWITCH
through a switch located on one of the armrests or
on the controller.
To change the seat height using the power el-
evating seat switch on the armrest:
1. Press forward on the power elevating seat switch
to raise the seat. See figure 19.
2. Pull back on the power elevating seat switch to
lower the seat
WARNING! Do not allow the motor
to run more than a few seconds
after the mechanism reaches the
top or bottom limit.
WARNING! The power elevating
seat option is intended for use on
a level surface only. Never raise the
seat from its lowest position on an
inclined surface. Failure to heed	Figure 19. Power Seat Switch
this warning can result in the
power chair tipping over.

WARNING! Never raise the seat from its lowest position when operating your power chair on bumpy or uneven surfaces. Failure to heed this warning can result in the power chair tipping over.

WARNING! Never raise the power elevating seat while your power chair is in freewheel mode.

WARNING! Always fasten the positioning belt when operating the power elevating seat.

NOTE: The power elevating seat option is equipped with a system that reduces the speed of the power chair by one half when the seat is el- evated more than 1–2 inches (2.5-5 cm). Always check to be sure this system is operating properly before using your power chair.

Quantum 1402 www.quantumrehab.com 27