V I . D I S A S S E M B L Y
Seat Removal
You may wish to remove the seat for transportation.
NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or
To remove the seat:
1.Turn off the power to the controller.
2.Make sure your power chair is not in freewheel mode. See III. “Your Power Chair.”
3.Unplug the controller connector from the electron- ics tray.
4.Flip up the seat latch safety. See figure 22.
5.Squeeze the seat latch and release the seat from the front trapeze bar.
6.Slide the seat forward and remove it from the power base.
To remove a power seat:
1.Turn off the power to the controller.
2.Disconnect the controller from the electronics tray.
3.Release the seat by moving the seat release lever backward.
4.Lift up the power seat plate.
5.Lift the seat off of the actuator.
Foot Platform Removal
The foot platform helps protect your power chair com- ponents from the environment. See figure 23. You must remove the foot platform in order to change the batter- ies and check the cable connections.
To remove the foot platform:
1.Turn off the power to the controller.
2.Make sure your power chair is not in freewheel mode. See III. “Your Power Chair.”
3.Remove the ball detent pin at the base of the foot platform bracket.
4.Lift the foot platform straight up approximately 2 in. (5 cm) and pull it away from the power base.
Figure 22. Seat Safety Latch
BALL DETENT PIN
Figure 23. Foot Frame Removal
Quantum 1402 | www.quantumrehab.com | 29 |
