Quantum Quantum 1402 manual Foot Platform Height Adjustment, Foot Platform Depth Adjustment

V . C O M F O R T A D J U S T M E N T S
7. Place the controller in the other armrest.
8. Tighten the setscrew.
9. Use a wire tie to secure the controller cable to	FOOT PLATFORM
the armrest.
	BRACKET NUTS AND
10. Plug the controller connector into the electron-
	BOLTS
ics tray.
NOTE: If your power chair is equipped with a Spe-	BALL DETENT
cialty Seat, Synergy Seat, or a TRU-Balance Power	PIN
Positioning System, refer to the information pro-
vided in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to one
of six different heights in 1-in. (2.54 cm) incre-
ments.
To raise or lower the foot platform:

1. Remove the nuts and bolts from the foot plat-	Figure 17. Foot Platform Height/Depth Adjustment
form bracket. See figure 17.

2.Raise or lower the foot platform to the desired height.

3.Reinstall the bolts and nuts into the foot plat- form bracket and retighten.

Foot Platform Depth Adjustment

To adjust the foot platform depth:

1.Remove the nuts and bolts from the foot platform bracket. See figure 17.

2.Move the foot platform in or out to the desired depth.

3.Reinstall the nuts and bolts into the foot plat-

form bracket and retighten.

Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with	SETSCREW
a hex key. See figure 18.
To adjust the foot platform angle:
1. Locate the setscrew on the underside of the foot	Figure 18. Foot Platform Angle Adjustment
platform.

2.Turn the setscrew to raise or lower the front of the foot platform.

26 www.quantumrehab.com Quantum 1402