Quasar HQ-2081TH manual Cabinet Installation, Features

Cabinet Installation

1.Open the window. Mark a line on center of the window sill (or desired air conditioner location).

Carefully place the cabinet on the window sill and align the center mark on the bottom front with the center line marked in the window sill.

2.Pull the bottom window sash down behind the upper guide until it meets.

NOTE:

•Do not pull the window sash down so tightly that the movement of Frame Curtain is restricted.

Upper Guide
	Window sill
	Front Angle	Fig. 1
Window Sash	Upper guide 9
Foam-pe 13
Cabinet
Frame Curtain 1
Foam-pe 10		Fig. 2

3.Loosely assemble the sill support using the parts in Fig. 3.

4.Select the position that will place the sill support near the outer most point on sill (See Fig. 4)

NOTE: Be careful when you install the cabinet (frame guides are broken easily).

5.Attach the sill support to the cabinet track hole in relation to the selected position using 2 Type A screws in each support (See Fig. 4).

6.The cabinet should be installed with a very slight tilt (about 1/2") downward toward the outside (See Fig. 5).

Adjust the bolt and the nut of sill support for balancing the cabinet.

7.Attach the cabinet to the window sill

by driving the screws (Type B) through the front angle into window sill.

8.Pull each Frame curtain fully to each window sash track, and repeat step 2.

INDOOR	OUTDOOR
	Sill Support 2
Bolt 3	Nut 4	Fig. 3
Frame Guide 11	Screw (Type A) 5		")
				Features
			12.7mm (1/2
	Cabinet		About	and
INDOOR	OUTDOOR Fig. 4			Installation
Screw (Type B) 6			12.7mm (1/2")
	Sill support 2		About

Sash track

Front Angle

Screw (Type B) 6 Fig. 5

Sill support 2

11