Quasar V V-1303B, V V-1303A, V V-2003A operating instructions Manual Clock Set, Press

Manual Clock Set

If AUTO CLOCK SET was incomplete, manually set the clock as follows.

1	Press ACTION				on the remote to
	display SET CLOCK Menu screen.
					SET C LOC K
			1 /		/		:
						DST : O N
		SE	LE C T M O N TH
		SE		LE C T:
		SET			:
		END			: ACT I O N
	Press				to select the month
	and press				to set. In the same
2 manner, select and set the date,
	year, time, and DST. (Daylight
	Saving Time)
					SET CLOCK		12:00PM
			4 /		5/2003 SAT
						DST : ON
	SET COMPLETED
		SET			:
3		START : ACT I ON
	Press ACTION				twice to start

CLOCK and exit.

POWER

	SELECT/SET
	:CH UP
ACTION	:CH DOWN
	:VOL UP
	:VOL DOWN

	Reset all unit Memory Functions
		Initial
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.		Setup
	<Model VV-2003A unit shown>

	POWER VOLCH STOP/EJECT REW/ PLAY/REPEAT FF/ REC	TIMER
1	Turn the unit
	Power on.
2	Press and hold both	PLAY and
	FF on the unit for more than 5

seconds.

•The power will shut off.

•Please ignore “NO CASSETTE” warning.

3 Do “Initial Setup” on page 8.

Note to CABLE System Installer

This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies

that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

9