5.3.1 QTPCI.EXE
Quatech's "QTPCI" utility supplies the information required when modifying the serial port settings of the application. This program should be run from real DOS, not in a Windows DOS box.
Figure 4 shows the Basic Mode display for the QSC(LP)-200/300 after the "Q" key has been pressed. In this example, the QSC(LP)-200/300 uses I/O base address FFA0 hex and IRQ 3. The hardware revision of the QSC(LP)-200/300 is also displayed. Pressing the "N" key will show similar information for all non-Quatech PCI devices in the system, including those devices integrated on the motherboard.
The QTPCI program is capable only of displaying the PCI configuration. It cannot be used
to make changes.
Figure 4 --- QTPCI.EXE Basic Mode display
Quatech | 22 |
