Manuals / Quatech / Computer Equipment / Network Card

Quatech DSCLP-300 Jumpers J10-J23 define the options for this card, Right Card Edge Jumpers

Models: DSCLP-300 SSCLP-200 SSCLP-300 DSCLP-200

1 48

Download 48 pages 22.06 Kb

Page 11

Image 11

Jumpers J10-J23 define the options for this card:

SPAD

J2 J3

J4

J5

J10

J11

J12

J13

J14

J15

J16

J17

J18

J19

J20

J21

J22

J23

X8

X4

X2

CTS0_SEL AUX0_SEL0 AUX0_SEL1 RCLK0_SEL TGL0_SEL0 TGL0_SEL1 RXEN0_SEL CTS1_SEL AUX1_SEL0 AUX1_SEL1 RCLK1_SEL TGL1_SEL0 TGL1_SEL1 RXEN1_SEL

Figure 2 - Right Card Edge Jumpers

DSCLP/SSCLP-200/300 User's Manual

11

Image 11

Quatech DSCLP-300, SSCLP-300, SSCLP-200, DSCLP-200 Jumpers J10-J23 define the options for this card, Right Card Edge Jumpers

Contents

DSCLP/SSCLP-200/300 Warranty Information Iii Standards to which Conformity is Declared Manufacturers NameManufacturers Address Application of Council Directive Base Address and Interrupt Level IRQ Hardware ConfigurationHardware Installation Address Map and Special Registers RS-422 or RS-485 Signal Line Termination Half-Duplex/Full-Duplex/Auto-Toggle Selection Page General Information Jumpers J6-J9 Full-duplex/Half-duplex Operation Signal Connections Right Card Edge Jumpers Jumpers J10-J23 define the options for this card 1 CTS0SEL, CTS1SEL J10 Force High-Speed Uart Clock X2, X4, or X8 J3, 4 Enable Scratchpad Register SPAD, J2Clock Rate and Optional Registers Clock multiplier jumper options Jumper/connector locations Hardware Installation Channel Address Range Bit Description Enabling the Special RegistersInterrupt Status Register Dlab Bit Spad Jumper Register selected for Quatech Modem Control Register Quatech Modem Control Register Write Read Options RegisterBit Name Description Clock Rate Uart Clock Maximum Data Multiplier Frequency Clock Rate Multiplier Windows Millennium Windows Configurations Windows Windows Page Windows Windows NT Viewing Resources with Device Manager Two-Port RS-422/RS485 Serial Adapter Page DSCLP-200/300 Two-Port RS-422/485 Serial Adapter Page Page Page Page DOS and other operating systems Other Operating SystemsOS/2 QTPCI.EXE QTPCI.EXE Expert Mode display Jumper/Channel correspondence External Connections Rclk RTS/CTS Handshake AUXIN/AUXOUT Loopback Tclk Half-Duplex/Full-Duplex/Auto-Toggle Selection Half/full-duplex and Auto-Toggle selection RS-422/485 Line termination resistance values Termination Resistors RS-422/485 Peripheral Connection DSCLP-200/300 connector definitions INTA# PCI Resource Map With 64-byte FIFOs optional Specifications Cannot communicate with other equipment TroubleshootingComputer will not boot up DSCLP/SSCLP-200/300