Windows NT | Quatech DSCLP-200, SSCLP-300, SSCLP-200, DSCLP-300

8.The installation utility will ask for your Windows 95 installation disks. Serial communication ports require two drivers supplied by Microsoft to function: SERIAL.VXD and SERIALUI.DLL. Insert the disk or CD and click "OK".

NOTE:

You may be able to skip this step if you are certain that your system has the latest version of these files installed. If you do not have your Windows 95 install disks immediately available, click "OK" anyway. A dialog box appears with an option to Skip the files. Click the Skip button and the files will not be installed. This is all right if the latest version of these drivers are currently in the \WINDOWS\SYSTEM directory.

9.The "New Hardware Found" dialog will repeat for each of the serial ports on the DSCLP-200/300 as each port is registered with Windows 95.

10.Installation is complete.

5.5 Windows NT

The Windows NT device driver is installed by running the SETUP program. Up to 256 serial ports are supported. There is a command line-based configuration utility which is used for adding PCI bus and ISA bus serial ports. Please refer to the documentation included with the device driver for full installation and configuration details.

DSCLP/SSCLP-200/300 User's Manual

26

Image 26

Quatech DSCLP-200, SSCLP-300, SSCLP-200, DSCLP-300 user manual Windows NT

Contents

DSCLP/SSCLP-200/300 Warranty Information Iii Application of Council Directive Manufacturers NameManufacturers Address Standards to which Conformity is Declared RS-422 or RS-485 Signal Line Termination Hardware ConfigurationHardware Installation Address Map and Special Registers Base Address and Interrupt Level IRQ Half-Duplex/Full-Duplex/Auto-Toggle Selection Page General Information Jumpers J6-J9 Signal Connections Full-duplex/Half-duplex Operation Jumpers J10-J23 define the options for this card Right Card Edge Jumpers 1 CTS0SEL, CTS1SEL J10 Force High-Speed Uart Clock X2, X4, or X8 J3, 4 Enable Scratchpad Register SPAD, J2Clock Rate and Optional Registers Clock multiplier jumper options Hardware Installation Jumper/connector locations Channel Address Range Dlab Bit Spad Jumper Register selected for Enabling the Special RegistersInterrupt Status Register Bit Description Quatech Modem Control Register Quatech Modem Control Register Write Read Options RegisterBit Name Description Clock Rate Multiplier Clock Rate Uart Clock Maximum Data Multiplier Frequency Windows Configurations Windows Millennium Windows Windows Page Windows Windows NT Viewing Resources with Device Manager Two-Port RS-422/RS485 Serial Adapter Page DSCLP-200/300 Two-Port RS-422/485 Serial Adapter Page Page Page Page DOS and other operating systems Other Operating SystemsOS/2 QTPCI.EXE QTPCI.EXE Expert Mode display External Connections Jumper/Channel correspondence RTS/CTS Handshake Rclk Tclk AUXIN/AUXOUT Loopback Half-Duplex/Full-Duplex/Auto-Toggle Selection Half/full-duplex and Auto-Toggle selection Termination Resistors RS-422/485 Line termination resistance values DSCLP-200/300 connector definitions RS-422/485 Peripheral Connection PCI Resource Map INTA# Specifications With 64-byte FIFOs optional Cannot communicate with other equipment TroubleshootingComputer will not boot up DSCLP/SSCLP-200/300