After Selecting IP Configuration key in the IP Address of the USB device server in the IP Address field followed by proper Subnet Mask & Gate Way as shown below.
After entering IP address, Subnet Mask & Gate Way then click on “save” button. Then USBIP Admin shows progress bar for some time and after it pops up a message box as shown below.
Note: Every board in the network is identified by its IP address. The utility treats each IP address as unique device. Even if the IP address of the box is modified it treats the same box as a different device and will pop up a Found New Hardware Wizard.
Continue the Found New Hardware Wizard to install the Virtual
Password:
The Password Settings page allows you to change or Enable/Disable password of the USB device server. The Password settings page will be as shown below.
