![](/images/new-backgrounds/1118493/11849333x1.webp)
Chapter 2 Installation and Setup | |
|
|
Opening the ASM-60 Case
➤To open the ASM-60 case:
1.Disconnect the power cord from the power source.
2.Slide the blue side panel forward to detach it from the case.
3.Unscrew the two screws located on the bottom panel at the rear end of the unit.
4.Separate the two halves of the
Closing the ASM-60 Case
After completing the internal settings, close the unit case.
➤To close the ASM-60 case:
1.Position the lower half of the
2.Return the top cover. Make sure that the front board CONTROL DCE connector fits the front panel opening correctly, and the top cover guides enter the corresponding recesses at the end of the unit.
3.Secure the two screws located at the end of the unit.
4.Fit the inside tabs of the blue side panel into the unit case grooves, and slide the side panel until it snaps into place.
Connecting the Interfaces
Figure 2-1 shows the rear panel of a typical ASM-60 unit with HSSI interface.
CAUTION : FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE.
HSSI
LINE
|
|
|
|
|
|
|
|
4 |
Figure 2-1 Rear Panel of ASM-60 with HSSI Interface
Connecting the Line
The
➤To connect the RJ-45 connector:
• Connect the line cable to the
Table
Pin | Function |
|
|
1, 2 | Line A |
|
|
4, 5 | Line B |
|
|
11, 12 | Chassis |
|
|
Installation and Setup |