Radio Shack 43-1122 owner manual Adjusting the HANDSET’S Volume, Using Redial, Using Flash, Paging

ADJUSTING THE HANDSET’S VOLUME

To adjust the volume of the sound you hear through the handset during a call, press 8 or 9 on the handset until you obtain the desired volume level. Lebkc[ CWn_ckc, Lebkc[ >_]^, Lebkc[ C[Z_kc, or Lebkc[ Bem appears on the handset display. Once you set the volume level, the setting is maintained even after you hang up the phone.

Note: When you press 8 while the volume is maximum or 9 while the volume is low, the setting does not change. The phone sounds three short beeps.

USING REDIAL

You can quickly dial the last number you dialed. Lift the handset and press REDIAL/ PAUSE, then TALK. The phone dials the number.

Notes:

•You can also press REDIAL/PAUSE after pressing TALK.

•The redial memory holds up to 32 digits, so you can redial long-distance as well as local numbers.

•The redial memory also holds pause entries (see “Entering a Pause” on Page 14).

USING FLASH

FLASH performs the electronic equivalent of a switchhook operation for special services, such as Call Waiting. For example, if you have Call Waiting, press FLASH to answer an incoming call without disconnecting the current call. Press FLASH again to return to the first call.

Note: If you do not have any special phone services, pressing FLASH might disconnect the current call.

USING TONE SERVICES ON A PULSE LINE

Some special services require tone signals (such as bank-by-phone). If you have pulse dialing, you can still use these special tone services.

Dial the service’s main number. When the service answers, press ∗/TONE/6. Any additional numbers you dial are sent as tone signals.

The phone’s dial mode resets to pulse when you make or receive a call.

PAGING

To send a page from the base to the handset or to locate the handset when the phone is not in use, press PAGE/FIND on the base. The handset beeps for about 1 minute.

FW]_d] appears on the handset while the page sounds.

To stop the page, press any key on the handset, place the handset on the base, or press PAGE/FIND on the base again.

Note: The phone rings when a call comes in while you are using the page feature.

USING A HEADSET

You can make or answer calls with hands- free convenience using an optional headset that has a 3/32-inch (2.5-mm) plug. Your local RadioShack store has a variety of headsets available.

To connect the headset, gently flip open the rubber headset jack cover on the side of the handset, then insert the headset’s plug into the jack.

12 Operation