Notes:
•Connecting a headset disconnects the handset’s earpiece and microphone.
•8 or 9 on the handset also controls the headset’s volume.
•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.
•With a headset connected, you can make or answer calls as usual using the keys on the handset.
•You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.
•When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.
MEMORY DIALING
You can store up to 10 phone numbers and names in memory, then dial a stored number by entering its memory location number.
Each number can be up to 20 digits, and each name can be up to 14 characters.
Storing a Number and Name in Memory
1.Lift the handset.
2.Hold down MEM until C[ceho Ijeh[ and a list of memory location numbers appears.
3.Select an empty memory location (or the
one you want to replace) by entering the location number
4.Press SELECT. Ijeh[ DWc[ appears. If you do not want to enter a name, skip to Step 6.
5.To enter a name, use the number keys.
Refer to the letters on the number keys to select the desired letter. Press the key once for the first letter in the upper case, press twice for second letter in the upper case, and so on. To enter the lower case letter, press four times (or five times) to display the first letter in lower case, five or six times for second letter, and so on.
For example, to enter John: press 5 once; upper case @ appears. Then press 6 six times; lower case e appears. Press 4 five times; lower case ^ appears. Finally, press 6 five times; lower case d appears.
To enter two letters from the same key in a row, press #/7 to move the cursor to the next position. For example to enter
AB, press 2; 7 appears. Then press #/ 7, the cursor moves to next position, then press 2 twice so 8 appears.
To enter a space, press #/7 twice without entering any character.
To enter a number, repeatedly press the corresponding number key until the number appears.
To enter a special character, press 0. Each time you press 0, the following characters appear in this order:
∗# ¶ & âýá (space) &
If you make a mistake, use ∗/TONE/6 or #/7 to move the cursor over the error, then enter the correct character, or press DELETE to delete a character. To delete all characters, hold down DELETE for at least 1 second.
6. Press SELECT. Ijeh[ DkcX[h appears.
Operation | 13 |
