Radio Shack 43-3537 owner manual 100%6+01%*#4+06* $#6642#%, 566+06*4+04610#0, ýR9#40+0R

#"+/2146#06"#

• The EPA certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates RadioShack is voluntarily participating in an

industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-THE-SHACK (1-800- 843-7422) for information on Ni-Cd battery recycling and disposal bans/restrictions in your area. RadioShack’s involvement in this program is part of the company’s commitment to preserving our environment and conserving our natural resources.

•Be sure the battery pack is properly connected before you try to charge it. The CHARGE/IN USE indicator lights when the handset is on the base, even if the battery pack is not connected.

ýR"9#40+0)"R"

Dispose of the old battery pack promptly and properly. Do not burn or bury it. See “Battery Safety Instructions” on Page 8 for additional information on proper battery handling.

5.Lift the base’s antenna to a vertical position.

10"#"9#..

To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base.

1.Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads extend about 1/8 inch (3 mm) from the wall.

2.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the base.

3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.

4.Route the adapter and modular cords through the grooves on the bottom of the base.

5.Align the base’s keyhole slots with the mounting screws and slide the base downward to secure it.

6.Plug the modular cord’s other end into the phone jack, and plug the adapter into a standard AC outlet.

7.Lift the base’s antenna to a vertical position.

%100'%6+0)1%*#4)+0)"6*'" $#66'4;"2#%-

The phone comes with a rechargeable nickel- cadmium battery pack in the handset, but not connected. Before using your phone, you must connect the battery pack, then charge it for about 15– 20 hours. #

1.Press down and slide off the battery compartment cover.

2.Lift the battery pack out of the compartment.

3.Plug the battery pack’s connector into the socket in the compartment (the connector fits only one way), then place the battery pack in the compartment.

4.Replace the cover.

To charge the battery pack, place the handset face-up or face-down on the base.

The CHARGE/IN USE indicator on the base lights and JejWb0&& appears on the handset

display.

Recharge the battery pack when Bem 8Wjj[ho flashes on the display.

If you have trouble replacing the battery pack, take the phone to your local RadioShack for assistance. Rý"#"

4'%*#4)+0)"6*'"$#66'4;"2#%-

•When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear an error tone when you press TALK. While holding PAGE, return the handset to the base for about 3 seconds to reset the security access-protection code.

•If the base loses power for about an hour while the handset is away from it, the security access-protection code might be lost. To reset the code, while holding PAGE, return the handset to the base for about 3 seconds.

•If the battery pack becomes weak during

a call, the handset beeps every 3 seconds and Bemý8Wjj[ho flashes. When this happens, you cannot make a call until you recharge the battery pack.

•If the display is blank and the phone does not work, recharge the battery pack. (The battery power might be too low to light the display.)

•About once a month, fully discharge the

battery by keeping the handset off the base until Bemý8Wjj[ho flashes on the display. Otherwise, the battery pack loses its ability to fully recharge.

•The handset loses its security access- protection code if the battery pack is completely discharged. While holding PAGE, place the handset on the base to recharge the battery pack and reset the code.

•Using a pencil eraser, clean the charging contacts on the handset and base about once a month.

•If you are not going to use your phone for an extended period, disconnect the battery pack. This increases the battery pack’s usable life.

•The supplied battery pack should last for about a year. If the battery pack does not hold a charge for more than 2 hours after an overnight charge, replace it with a new 3.6-volt, 600 mAh battery pack with a connector that fits the socket in the battery compartment. You can order a replacement battery pack through RadioShack. Install the new battery pack and charge it for about 15– 20 hours.

5'66+0)"6*'"4+0)'4"610'"#0&" 81.7/'

You can select one of five different ringer tone/volume settings on the handset. Lift the handset and repeatedly press VOL 8 or 9 to select the desired ringer setting. Each time you press the button, the phone rings at the

4