Radio Shack 64, 65 owner manual VCR Setup, Setting the VCR’S Output Channel Switch, Remote Control

16-634.fm Page 13 Tuesday, July 20, 1999 5:37 PM

VCR SETUP

SETTING THE VCR’S OUTPUT CHANNEL SWITCH

If you connected the VCR’s OUT TO TV termi- nal to a TV or another VCR, set 3-CH-4on the back of the VCR to 3 or 4, whichever is not an active channel in your area.

When VCR appears on the display, the VCR sends the signal from the video source con- nected to its IN FROM ANT. or R-AUDIO-L IN 1/ VIDEO IN 1 (or AV2 on the front panel) terminals to the TV on the channel you selected.

Note: Setting 3-CH-4 has no effect on the TV when the VCR is off or if you connected a TV with separate audio/video input jacks to the VCR’s R-AUDIO-L/VIDEO OUT jacks.

REMOTE CONTROL

Installing Batteries

The remote control requires two AA batteries (not supplied). For the longest operation and best performance, we recommend alkaline bat- teries (such as RadioShack Cat. No. 23-557).

Cautions:

2.Put fresh batteries in the compartment as indicated by the polarity symbols (+ and –) marked inside.

3. Replace the cover.

Note: When the remote control stops working or operates poorly, replace both batteries.

Cautions:

•Never leave dead or weak batteries in the remote control. Batteries can leak chemi- cals that can damage your remote control.

•Dispose of dead batteries promptly and properly; do not bury or burn them.

Using the Remote Control

•Use only fresh batteries of the required size and recommended type.

•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.

1.Press the tab on the battery compartment cover and lift off the cover in the direction of the arrow.

To use the remote control, aim it at the front of the VCR and press the desired function but- tons.

Tab

13