Radio Shack ET-1105 Setting the Area Code, Setting the Ringer, Turning the Ringer On or Off

SETTING THE AREA CODE

When you return a call from a Caller ID record (see “Dialing Numbers from a Caller ID Record” on Page 21), your phone automatically dials 1, the area code, and the number. The ET-1105 lets you store one local area code and three neighborhood area codes. If the number you call has the same area code with your local area code, the ET-1105 dials the 7-digit local number. If the number you call has the same area code with one of three neighborhood area codes, the ET-1105 dials the 10-digit local number.

Follow these steps to set area codes.

Note: If you make a mistake or do not press a key within 10 seconds during these steps, start again at Step 1.

1.Pres SETUP. The language selection display appears.

2.Press /. The currently entered area codes (or AREACODE=000 000/000/000) appear.

SETTING THE RINGER

Turning the Ringer On or Off

You can turn the ET-1105’s ringer on and off. Set RINGER on the side of the handset to ON to hear an incoming call or a page from the base. Set RINGER to OFF to silence the ringer.

Note: With the ringer off, you can still make or receive calls using this cordless phone. Telephones on the same line still ring when there is an incoming call, and the IN USE indicator on the ET-1105’s base flashes until you answer the call.

RINGER

/

3.Enter your local area code first, then the three neighborhood area codes, then press SETUP to store them.

Checking/Setting the Ringer

You can set the ET-1105’s handset to sound any of three ringer types. The handset is preset to use the ringer tone (1). To change or hear the different tones, press FLASH when the phone is not in use. PROG. RINGER displays. With RINGER set to ON, press 1, 2, or 3, then press FLASH to confirm the setting. (The last number button you pressed is the tone you will hear.)

12