3.Route the adapter and modular cords through the grooves on the bottom of the base.
4.Plug the modular cord’s other end into the wall plate jack, then align the base’s keyhole slots with the wall plate studs and slide the base downward to secure it.
7.Lift the base’s antenna to an upright position.
Note: To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base.
Follow the steps under “On a Wall Plate or Wall” on Page 5, then apply these ad- ditional instructions for placement on a wall.
1. Drill two holes 315/16 |
| ||
inches | (100 | mm) |
|
apart. Then thread |
| ||
a screw | into | each |
|
hole, letting | the | 315/16 | |
heads extend about | Inch | ||
5/16 inch (8 mm) |
| ||
from the wall. |
|
| |
5.Plug the adapter into a standard AC outlet.
6.Press and lift out the handset holder, rotate it 180°, then snap it back into place so it holds the hand-
set.
Handset
Holder
2.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the base.
3.Align the base’s keyhole slots with the mounting screws and slide the base down to secure it.
6
