Radio Shack ET-3507 Storing Your Area Code, Using the Data Port, Setting UP the Cordless Handset

TEL LINE

DATA PORT

2.Press ; to darken the display, or : to lighten the display.

Note: The phone sounds 3 beeps when you reach the lowest or highest contrast level.

3.Press FUNCTION to save the new setting and enter the area code setting mode. 7H;7 9E:; 3 ###

appears.

Note: In Steps 2 and 3, if you do not press a key within 12 seconds, the corded phone exits the display contrast setup.

STORING YOUR AREA CODE

To dial a number from a Caller ID or VIP record (see “Dialing a Number From a VIP or Caller ID Record” on Page 17), you must first store your local area code in the phone’s memory. Then, when you dial from a Caller ID or VIP record, the system skips the area code if it matches the one you stored.

Note: Do not store the area code if your area requires ten digit dialing. Otherwise, it dials incorrectly on call back.

Corded Phone

When 7H;7 9E:; 3 ### appears, enter your three-digit area code within 12 seconds. The phone beeps twice. The area code is stored and the phone returns to standby mode. To replace a stored area code, store a new one in its place.

Note: If you are not in the Area Code setting mode, hold down FUNCTION for 2 seconds, then press FUNCTION again to skip the display contrast mode. 7H;7 9E:; 3 ###

appears.

Cordless Handset

Press and hold #/FUNC on the cordless handset until 7H;7 9E:; 3 ### appears. Enter your three-digit area code within 12 seconds. The cordless handset beeps twice. The area code is stored and the cordless handset returns to standby mode. To replace a stored area code, store a new one in its place.

USING THE DATA PORT

The corded phone is equipped with an extra phone jack that allows you to connect to a computer modem. You

need a modular cord (available at your local RadioShack store) to connect the phone to a computer modem.

DC 12V

300mA Jack

DATA PORT

Plug one end of the modular cord into the

jack on the back of the corded phone. Plug the modular cord’s other end into a computer modem’s telephone line jack.

Note: You cannot use the data port and the telephone at the same time.

SETTING UP THE CORDLESS HANDSET

Resetting the Security Access-Protection Code

If the cordless handset does not work immediately after charging or recharging the battery pack, you must reset the security access-protection code (see “Connecting, Charging and Replacing the Cordless Handset’s Battery Pack” on Page 7).

1.Hold down DELETE on the corded phone for until >I H;=?IJH7J?ED appears.

2.Within 12 seconds, hold down FLASH/DELETE on the cordless handset untilý?D?J?7B?P7J?ED$$ appears.

Note: If you wait longer than 12 seconds, the phone exits security code setup.

3.Once the cordless handset successfully receives the security code from the corded phone, the cordless

handset and the corded phone beeps twice. 9ED<?HC;: appears on both phones.

Using a Headset

You can make or answer calls with hands-free convenience using an optional headset that has a 3/32 -inch (2.5 mm) plug. Contact your local RadioShack store for a suitable headset.

To connect the headset, insert the headset plug into the headset jack on the cordless handset.

Preparation 9