Radio Shack ET-910 owner manual Using Flash, Changing Channels

43-1085.fm Page 20 Tuesday, August 17, 1999 2:31 PM

USING FLASH

You can use FLASH to produce a switchhook signal for special phone services, such as call waiting. If you have call waiting, press FLASH to take an incoming call without discon- necting the current call. Press FLASH again to return to the first call.

		TONE	OPER 0	#
		PRIVACY / LOW BATT
TALK	INT.CM	MEM	PROG	REDIAL
		OFF
1	ABC 2	DEF 3
		HOLD	FLASH	PRIVACY
GHI 4	JKL 5	MNO 6
PRS 7	TUV 8	WXY 9
		INT.CM		SPKR
TONE	OPER0	#	VOLUME
HOLD	FLASH	PRIVACY
MEM	PROG	REDIAL
		DIGITAL

Note: If you do not have any special phone services, pressing FLASH might disconnect the current call.

USING TONE SERVICES ON A PULSE LINE

If you have pulse service, you can temporarily switch to sending tones for banking services or computer transactions.

Dial the number as usual, then sim- ply press TONE at the appropriate place in the call to change to tone di- aling. The phone automatically re- turns to pulse dialing when you end the call.

20

CHANGING CHANNELS

The ET-910 continuously scans 10 channels (frequency pairs used be- tween the base and the handset) and automatically selects the one with the least interference each time you make or receive a call using the handset.

If you notice interference during a call, however, you can repeatedly press INT.CM on the handset to try and find a clearer channel. The ET- 910 changes to a different channel each time you press the key.

			/
TALK		INT.CM	OFF
	1	ABC 2	DEF 3
GHI	4	JKL 5	MNO 6
PRS	7	TUV 8	WXY 9
TONE		OPER 0	#
HOLD		FLASH	PRIVACY
MEM		PROG	REDIAL

Note: You cannot change the chan- nel while using HOLD.