Radio Shack ET-910 owner manual Storing a Pause in Memory, Dialing a Stored Number

43-1085.fm Page 22 Tuesday, August 17, 1999 2:31 PM

To store additional numbers, repeat Steps 1-4 for each number you want to store.

Notes:

•To change a number in memory, simply store a new one in its place.

•To erase a number from mem- ory, repeat Steps 1-4, and skip Step 3.

•Write the memory location num- ber and name associated with each stored phone number on the memory dialing card. We recommend you use a pencil in case you want to change the name later.

		1	ABC 2	DEF 3
		GHI 4	JKL 5	MNO 6
		PRS 7	TUV 8	WXY 9
MEMORY DIALING		TONE	OPER 0	#
•	•
•	•
•	•	MEM	PROG	REDIAL
•	•
•	•
		HOLD	FLASH	PRIVACY

Storing a Pause in Memory

In some telephone systems, you must dial an access code (9, for ex- ample) and wait for a second dial tone before you can dial an outside number. You can store the access code with the phone number. How- ever, you should also store a pause after the access code to allow the outside line time to connect.

22

To add one or more 2-second paus- es to a phone number you are storing in memory, press HOLD at each point where a pause is needed.

		TONE	OPER 0	#
		PRIVACY / LOW BATT
TALK	INT.CM	MEM	PROG	REDIAL
		OFF
1	ABC 2	DEF 3
		HOLD	FLASH	PRIVACY
GHI 4	JKL 5	MNO 6
PRS 7	TUV 8	WXY 9
		INT.CM		SPKR
TONE	OPER0	#	VOLUME

HOLD FLASH PRIVACY

MEM PROG REDIAL

DIGITAL

Note: Each pause entry counts as one memory digit in the stored num- ber.

Dialing a Stored Number

To dial a number stored in memory, when you hear the dial tone, press MEM then the desired memory loca- tion number (0-9).

			TONE	OPER 0	#
		PRIVACY / LOW BATT
TALK	INT.CM	OFF	MEM	PROG	REDIAL
1	ABC 2	DEF 3
			HOLD	FLASH	PRIVACY
GHI 4	JKL 5	MNO 6
PRS 7	TUV 8	WXY 9	INT.CM		SPKR
TONE	OPER0	#		VOLUME

HOLD FLASH PRIVACY

MEM PROG REDIAL

DIGITAL

Note: If you select a memory location number that does not have a phone number stored in it, press MEM again then press the correct memory loca- tion number.