Radio Shack TAD-1016 owner manual Setting the TAD to Answer Calls

43-775.fm Page 25 Friday, August 13, 1999 3:25 PM

3.When you finish your message, press STOP/7. The TAD beeps, plays back the message, then beeps again.

Note: If your message is less than 2 seconds, the TAD does not recognize it as a new message, and plays back the previous pre-recorded message. Re-record your message and make sure it is longer than 2 seconds.

To delete your personal message and use the pre-recorded messages again, hold down OGM REC/8 for about 2 seconds until the TAD beeps. Then, within 2 seconds, press STOP/7.

SETTING THE TAD TO ANSWER CALLS

To set the TAD to answer calls, press ANSWER on the base. The number of calls in the TAD’s memory (or 0) ap- pears on the display if you set the TAD to announce and record, or A ap- pears if you set it to announce only.

You can also set the TAD from the handset. Press REMOTE so the BATT LOW indicator lights green. After the TAD announces the current outgoing message (either a pre-recorded mes- sage or your personal message), press ANSWER/6 to set the TAD to an- swer calls.

Notes:

•If the incoming message memory capacity has less than 5 minutes left, the TAD announces “Remain- ing time, xx minute(s)” when you set the TAD to answer calls.

•If the incoming message memory capacity is full (40 messages or less than 1 minute left), the TAD announces “No remaining time for incoming messages” and does not let you set it to answer calls.

To turn off the TAD, press ANSWER/6 on the handset or ANSWER on the base.

25