CHANGING THE REMOTE OPERATION SECURITY CODE
The remote operation security code is preset to 784, but you can change it by following these steps.
Note: Be sure to set each digit within 8 seconds. Otherwise, you must start over from Step 1.
1.Hold down CODE/SKIP until the TAD beeps once. Co appears.
2.Press CODE/SKIP again. Sc (securi- ty code) and the digits of the current code appear in sequence, then the first digit reappears.
For example, when the security code is 784, the display shows Sc (security code),
3.Repeatedly press SKIP/CODE or MEMO/REPEAT to set the first digit, then press ANSWER. The second digit appears.
16
Note: If you enter an incorrect digit, press STOP/TIME SET, then repeat the procedure.
4.Press SKIP/CODE or MEMO/REPEAT to set the second digit, then press ANSWER. The third digit appears.
5.Press SKIP/CODE or MEMO/REPEAT to set the third digit, then press AN- SWER. The TAD sounds a long beep.
To check the remote operation security code at any time, follow Steps 1 and 2, then press STOP/TIME SET to exit.
