TROUBLESHOOTING
If you experience problems with your TAD, try the suggestions in this section. If you still have problems, contact your local RadioShack store for assistance.
Problem | Remedy |
|
|
|
|
The incoming message is incomplete. | Be sure the memory is not full. |
|
|
The incoming message is unclear. | Be sure VOLUME is set to the desired sound |
| level. |
|
|
The TAD does not answer after two, | Be sure the TAD is set to answer calls. |
four, or seven rings. |
|
|
|
Lo flashes on the display. | The backup battery is weak. Replace the bat- |
| tery (see “Installing the Backup Battery” on |
| Page 7). |
|
|
The TAD does not respond to the | Make sure the phone you used to dial the TAD |
remote operation security code. | is a |
|
|
| |
| pressing each button for 2 seconds. |
|
|
| The remote operation security code might have |
| reset to the default code due to a power failure. |
| Make sure the remote operation security code |
| you entered is correct. |
|
|
RESETTING THE TAD
If your TAD stops working properly, use a straightened paper clip to press RESET on the left side of the TAD to reset the answer- ing machine.
Note: The outgoing message and all information stored in memory are erased when you press RESET.
19
