Radio Shack TAD-725 owner manual Memory Dialing, Storing a Number in Memory

43-725.fm Page 18 Tuesday, February 23, 1999 2:47 PM

MEMORY DIALING

You can store up to 10 numbers in memory, then dial a stored number by pressing MEM and a one-digit memory location number. Also, with the press of one button, M1, M2, or M3, you can dial a number that is stored in one of the first three memory locations.

Each number you store can be up to 16 digits long.

Use the supplied memory directory stickers to record your stored numbers. Peel the backing from each sticker and attach them to the phone as shown.

Storing a Number in Memory

1.Lift the handset (if the TALK/BATT indicator lights, press TALK to turn it off) and press MEM. The TALK/ BATT indicator blinks.

18

2.Enter the number and any PAUSE or TONE/ entries (see “Chain-Dialing Service Numbers” and “Entering a Pause” on Page 19).

Notes:

•An error tone sounds and the phone exits the programming mode if you wait more than 20 seconds between each key press.

•Each TONE/ or PAUSE entry uses one digit of memory.

•If you try to enter more than 16 dig- its, the phone beeps 5 times and ex- its the programming mode. Start over at Step 2 and enter no more than 16 digits in Step 3.

3.Press MEM again, then enter the memory location number (0–9) where you want to store the number. A tone sounds to indicate that the number is stored.

To replace a stored number, simply store a new number in its place.

To clear a stored number, lift the hand- set (if the TALK/BATT LOW indicator lights, press TALK to turn it off) and press MEM twice. Then press the memo- ry location number (0–9) you want to clear. A tone sounds.