Radio Shack TAD-725 owner manual Adjusting the TAD’S Volume, Deleting Messages

43-725.fm Page 24 Tuesday, February 23, 1999 2:47 PM

To replay the current message from the beginning, press REPEAT. If you press REPEAT within about 4 seconds after a message begins playing, the TAD re- plays the previous message.

REPEAT

ADJUSTING THE TAD’S VOLUME

To adjust the speaker’s volume, repeat-

edly press VOLUME or on the base. The volume setting from 1 (low- est) to 10 (highest) appears in the mes- sage counter window.

DELETING MESSAGES

To delete the current message while it is playing, hold down DELETE until the TAD beeps.

To delete all messages at once, while messages are not playing, hold down DELETE on the base until the TAD beeps and 0 appears in the message counter window.

Note: You cannot delete new (un- played) messages. If you try to delete all messages at once while you still have new messages, the TAD sounds five quick beeps and does not delete any messages.

24

SETTING THE REMOTE OPERATION PIN

The TAD-725’s two-digit remote opera- tion PIN (personal identification number) prevents unauthorized remote access to your messages. The PIN is preset to 80. Follow these steps to change the PIN to any number from 00 to 99.

Note: If you wait more than 2 minutes between each keypress, the TAD exits the PIN setting process. Start again at Step 1.

1.Hold down PIN until the TAD beeps and 00 appears in the message counter window.

REPEAT PIN SKIP

2.Press SKIP to set the first digit of the PIN higher or REPEAT to set it lower. Then press PIN.

3.Press SKIP or REPEAT to set the second digit of the PIN, then press PIN. The TAD announces the new PIN.

To check your PIN at any time, press PIN. The PIN appears in the message counter window, and the TAD announc- es it.

Note: If the TAD loses power for longer than about one hour, the PIN resets to 80.