its plug must fit the monitor’s
jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the monitor or the adapter.
•Always connect the AC adapter to the monitor before you connect it to AC power. When you finish, disconnect the adapter from AC power before you dis- connect it from the monitor.
To connect the monitor to AC power, insert the supplied adapter’s barrel plug into the DC 12V jack on the back of the monitor, then plug the other end of the adapter into a standard AC outlet. If you did not install batteries in the monitor, all programmed display characters appear, then the default time () and the weather element readings appear.
The monitor begins scanning and reading data from all components as soon as you connect AC power. Wait until the monitor
stops scanning before you make any adjust- ments.
Mounting the Monitor on a Wall
To mount the monitor on a wall, you need two wall screws (not supplied) with heads that fit the keyhole slots on the back of the monitor. The heads should be no larger than 0.31 inches (8 mm).
1.Drill two small pilot holes (each shallow and slightly smaller in diameter than the screw) 59/16 inches apart, one beside the other, at the desired mounting location.
2.Thread a screw into each hole until the screw’s head extends about 1/8 inch from the wall.
3.Place the keyhole slots on the back of the monitor over the screws, then slide the monitor down over the screws until it is securely in place.
Operation
SETTING THE TIME ZONE, TIME, DATE, AND LANGUAGE
Setting the Time Zone
The monitor automatically displays a time zone ( = Pacific, = Mountain, = Central, or = Eastern) in the Clock window while you set the clock. To set the time zone, hold
down CLOCK 
for about 2 seconds, then press 
or 
until your time zone appears. Press CLOCK 
to store the setting.
Notes:
•If you do not press a key for about 1 minute after you begin, the clock will
return to the current time display. Start over from Step 2.
•To keep the existing setting in any step, simply press SET.
1.Press CLOCK 
to enter the clock mode.
2.Hold down SET until the hour format ( or ) flashes.
3.Hold down 
or 
to set the time to the desired format.
4.Press SET. A letter representing the lan- guage used for the day of the week flashes.
5.Repeatedly press (or hold down) 
or 
until the desired language appears (
16 | Operation |